In mountain biking and even BMX riding, the bunny hop is a bike trick that involved the rider lifting the bike up and over an obstacle while remaining in motion on the bike.  Experienced bikers can lift their bikes in excess of a meter or one and a half feet.  The world record for the bunny hop stands at 4 feet.

The bunny hop is executed by approaching an obstacle with speed, lifting the front of the bike then leveling the pedals.  If the bike has full or front suspension, pre-load the shocks by pressing down on the bike just before you reach the obstacle.

Once the shocks have been pre-loaded, the rider will spring upwards, pulling up with the hands and feet at the same time.  Toe straps or clipless pedals help with this, although if plain platform pedals are used, it’s still possible.  As the biker lifts, the hands will roll through twisting the throttle.  After the object is cleared, push down on the bike then absorb the impact with the arms and the legs.

It’s often times a misconception that a bunny hop without toe clips is achieved by rotating forward on the handlebars.  Lifting up on a mountain bike while standing next to it is quite difficult to hold on to the handle bars.

The bunny hop is very popular with mountain biking, as experienced riders can make it look a lot easier than it actually is.  New mountain bikers should practice a lot before they actually attempt the hop, as doing it on a bigger obstacle can easily be quite dangerous.

With proper practice, the bunny hop can be achieved, even for beginners.  All you have to do is give it some time and effort, and you’ll be pulling off the bunny hop just like the pro’s do it.

A mountain bike is a lot of fun although it does require some maintenance.  You should always lube your bike 15 hours or so before riding, as quick jobs right before you take off normally doesn’t get everything lubed.  Some lube jobs will last for more rides, although if things get loud or shifting gets sticky, it’s time to lube.

Here is how to lube your bike:

1.  The chain
Apply a generous amount of mountain bike lube to your chain as you move the pedals around backwards.  It also helps to find a spot to steady your hand such as the frame while you move the pedals around and around.  Make sure you watch out for the cranks and chain rings as they move around.

2.  Front Deraileur
On the front defaileur, lube the pivots.  Use a spot of lube everywhere you can see movement when you move the shift lever.

3.  Rear deraileur
Just like the front deraileur, lube the pivots.

4.  Pedals
There are some types of clipless pedals that will need to have the release mechanism lubed.  You should only lube this mechanism if you have this type of pedal.

5.  Everything into motion
Pedal around, shift your gears, and bounce your bike around.  If you hear anything squeak, there’s a moving part there are it should be lubed immediately.

6.  Wipe it all clean
Once you’ve lubed everything and wiped it all around, simply wipe it all back off.  Use a rag to wipe away all the lube you used, including all the lube off the chain.  Wiping it away will leave the lube in between the parts but clean it away from everywhere it isn’t needed.  This will keep your bike from collecting dirt while you ride.